Displaying And Maintaining Super Vlan; Super Vlan Configuration Example - H3C S3600V2 SERIES Layer 2-Lan Switching Configuration Manual

Displaying and maintaining super VLAN

Task
Display the mapping between a
super VLAN and its sub-VLANs.

Super VLAN configuration example

Network requirements
As shown in
• Create super VLAN 10, and configure its VLAN interface IP address as 10.0.0.1/24.
Create the sub-VLANs VLAN 2, VLAN 3, and VLAN 5.
•
Assign Ethernet 1/0/1 and Ethernet 1/0/2 to VLAN 2, Ethernet 1/0/3 and Ethernet 1/0/4 to
•
VLAN 3, and Ethernet 1/0/5 and Ethernet 1/0/6 to VLAN 5.
The sub-VLANs are isolated at Layer 2 but connected at Layer 3.
•
Figure 47 Network diagram
Configuration procedure
# Create VLAN 10, and configure its VLAN interface IP address as 10.0.0.1/24.
<Sysname> system-view
[Sysname] vlan 10
[Sysname-vlan10] quit
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ip address 10.0.0.1 255.255.255.0
# Enable local proxy ARP.
[Sysname-Vlan-interface10] local-proxy-arp enable
[Sysname-Vlan-interface10] quit
# Create VLAN 2, and assign Ethernet 1/0/1 and Ethernet 1/0/2 to it.
[Sysname] vlan 2
[Sysname-vlan2] port ethernet 1/0/1 ethernet 1/0/2
[Sysname-vlan2] quit
# Create VLAN 3, and assign Ethernet 1/0/3 and Ethernet 1/0/4 to it.
[Sysname] vlan 3
Figure 47:
Command
display supervlan [ supervlan-id ] [ | { begin |
exclude | include } regular-expression ]
146
Remarks
Available in any view