Setting The Mtu For A Layer 3 Ethernet Interface; Displaying And Maintaining An Ethernet Interface - H3C S3600V2 SERIES Layer 2-Lan Switching Configuration Manual

Step
2. Set the traffic polling interval
of the storm control module.
3. Enter Ethernet interface view.
4. Enable storm control, and set
the lower and upper
thresholds for broadcast,
multicast, or unknown unicast
traffic.
5. Set the control action to take
when monitored traffic
exceeds the upper threshold.
6. Enable the interface to send
storm control threshold event
traps..
7. Enable the interface to log
storm control threshold
events..

Setting the MTU for a Layer 3 Ethernet interface

The maximum transmission unit (MTU) affects the fragmentation and re-assembly of IP packets.
To set the MTU for a Layer 3 Ethernet interface:
Step
1. Enter system view.
2. Enter Layer 3 Ethernet
interface view.
3. Set the MTU.

Displaying and maintaining an Ethernet interface

Command
storm-constrain interval seconds
interface interface-type
interface-number
storm-constrain { broadcast |
multicast | unicast } { pps | kbps |
ratio } max-pps-values
min-pps-values
storm-constrain control { block |
shutdown }
storm-constrain enable trap
storm-constrain enable log
Command
system-view
interface interface-type interface-number
mtu size
16
Remarks
Optional.
10 seconds by default.
N/A
Disabled by default.
Optional.
Disabled by default.
Optional.
By default, the interface sends
traps when monitored traffic
exceeds the upper threshold or
drops below the lower threshold
from the upper threshold.
Optional.
By default, the interface outputs log
messages when monitored traffic
exceeds the upper threshold or
drops below the lower threshold
from the upper threshold.
Remarks
N/A
N/A
Optional.
1500 bytes by default.