Shutting Down An Aggregate Interface; Restoring The Default Settings For An Aggregate Interface - H3C S3600V2 SERIES Layer 2-Lan Switching Configuration Manual

Step
1. Enter system view.
2. Enter aggregate interface view.
3. Set the minimum number of Selected
ports for the aggregation group.
4. Set the maximum number of Selected
ports for the aggregation group.

Shutting down an aggregate interface

Shutting down or bringing up an aggregate interface affects the aggregation state and link state of ports
in the corresponding aggregation group in the following ways:
• When an aggregate interface is shut down, all Selected ports in the corresponding aggregation
group become unselected and their link state becomes down.
When an aggregate interface is brought up, the aggregation state of ports in the corresponding
•
aggregation group is recalculated and their link state becomes up.
To shut down an aggregate interface:
Step
1. Enter system view.
2. Enter aggregate interface
view.
3. Shut down the aggregate
interface.

Restoring the default settings for an aggregate interface

Step
1. Enter system view.
Command
system-view
•
Enter Layer 2 aggregate
interface view:
interface bridge-aggregation
interface-number
•
Enter Layer 3 aggregate
interface view:
interface route-aggregation
interface-number
link-aggregation selected-port
minimum number
link-aggregation selected-port
maximum number
Command
system-view
•
Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
•
Enter Layer 3 aggregate interface
view:
interface route-aggregation
interface-number
shutdown
Command
system-view
47
Remarks
N/A
Use either command.
Not specified by default.
By default, the maximum
number of Selected ports
allowed in an aggregation
group is 8.
Remarks
N/A
Use either command.
By default, aggregate interfaces
are up.
Remarks
N/A