H3C S3600V2 SERIES Layer 2-Lan Switching Configuration Manual page 243

Type
Protocol Identity
NOTE:
• H3C devices support only receiving protocol identity TLVs.
Layer 3 Ethernet ports do not support IEEE 802.1 organizationally specific TLVs.
•
IEEE 802.3 organizationally specific TLVs
3.
Table 25 IEEE 802.3 organizationally specific TLVs
Type
MAC/PHY
Configuration/Status
Power Via MDI
Link Aggregation
Maximum Frame Size
Power Stateful Control
NOTE:
The Power Stateful Control TLV is defined in IEEE P802.3at D1.0. The later versions no longer support this
TLV. H3C devices send this type of TLVs only after receiving them.
LLDP-MED TLVs
LLDP-MED TLVs provide multiple advanced applications for voice over IP (VoIP), such as basic
configuration, network policy configuration, and address and directory management. LLDP-MED TLVs
provide a cost-effective and easy-to-use solution for deploying voice devices in Ethernet. LLDP-MED TLVs
are shown in
Table 26 LLDP-MED TLVs
Type
LLDP-MED Capabilities
Network Policy
Description
Indicates protocols supported on the port. An LLDPDU can carry multiple
different TLVs of this type.
Description
Contains the bit-rate and duplex capabilities of the sending port, support for
auto negotiation, enabling status of auto negotiation, and the current rate
and duplex mode.
Contains the power supply capability of the port, including the Power over
Ethernet (PoE) type, which can be Power Sourcing Equipment (PSE) or
Powered Device (PD), PoE mode, whether PSE power supply is supported,
whether PSE power supply is enabled, and whether the PoE mode is
controllable.
Indicates the aggregation capability of the port (whether the link is capable
of being aggregated), and the aggregation status (whether the link is in an
aggregation).
Indicates the supported maximum frame size. It is now the maximum
transmission unit (MTU) of the port.
Indicates the power state control configured on the sending port, including
the power type of the PSE or PD, PoE sourcing and receiving priority, and
PoE sourcing and receiving power.
Table 26.
Description
Allows a network device to advertise the LLDP-MED TLVs that it
supports.
Allows a network device or terminal device to advertise the VLAN ID of
the specific port, the VLAN type, and the Layer 2 and Layer 3 priorities
for specific applications.
228