Layer 2 Dynamic Aggregation Configuration Example - H3C S3600V2 SERIES Layer 2-Lan Switching Configuration Manual

The output shows that all link aggregation groups created on the device perform load sharing
based on source and destination MAC addresses.

Layer 2 dynamic aggregation configuration example

Network requirements
As shown in
Device A and Device B are connected through their respective Layer 2 Ethernet interfaces Ethernet
•
1/0/1 through Ethernet 1/0/3.
Configure a Layer 2 dynamic aggregation group on both Device A and Device B, enable VLAN 10
•
at one end of the aggregate link to communicate with VLAN 10 at the other end, and VLAN 20 at
one end to communicate with VLAN 20 at the other end.
Enable traffic to be load-shared across aggregation group member ports based on source and
•
destination MAC addresses.
Figure 15 Network diagram
Configuration procedure
Configure Device A:
1.
# Create VLAN 10, and assign the port Ethernet 1/0/4 to VLAN 10.
<DeviceA> system-view
[DeviceA] vlan 10
[DeviceA-vlan10] port ethernet 1/0/4
[DeviceA-vlan10] quit
# Create VLAN 20, and assign the port Ethernet 1/0/5 to VLAN 20.
[DeviceA] vlan 20
[DeviceA-vlan20] port ethernet 1/0/5
[DeviceA-vlan20] quit
# Create Layer 2 aggregate interface Bridge-Aggregation 1, and configure the link aggregation
mode as dynamic.
[DeviceA] interface bridge-aggregation 1
[DeviceA-Bridge-Aggregation1] link-aggregation mode dynamic
# Assign ports Ethernet 1/0/1 through Ethernet 1/0/3 to link aggregation group 1 one at a time.
[DeviceA] interface ethernet 1/0/1
Figure 15:
54