Table of Contents
Advertisement
Step
5.
Assign the port an
aggregation priority.
Configuring a dynamic aggregation group
NOTE:
To guarantee a successful dynamic aggregation, make sure that the peer ports of the ports aggregated at
one end are also aggregated. The two ends can automatically negotiate the aggregation state of each
member port.
Configuring a Layer 2 dynamic aggregation group
To configure a Layer 2 dynamic aggregation group:
Step
1.
Enter system view.
2.
Set the system LACP priority.
3.
Create a Layer 2 aggregate
interface and enter Layer 2
aggregate interface view.
4.
Configure the aggregation
group to work in dynamic
aggregation mode.
5.
Exit to system view.
6.
Assign an Ethernet interface
to the aggregation group.
Command
link-aggregation port-priority
port-priority
Command
system-view
lacp system-priority system-priority
interface bridge-aggregation
interface-number
link-aggregation mode dynamic
quit
•
Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
•
Assign the Ethernet interface to
the aggregation group:
port link-aggregation group
number
77
Remarks
Optional.
By default, the aggregation priority
of a port is 32768.
Changing the aggregation priority
of a port may affect the
aggregation state of the ports in
the static aggregation group.
Remarks
N/A
Optional.
By default, the system LACP priority
is 32768.
Changing the system LACP priority
may affect the aggregation state of
the ports in a dynamic aggregation
group.
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
By default, an aggregation group
works in static aggregation mode.
N/A
Repeat this step to assign more
Layer 2 Ethernet interfaces to the
aggregation group.
Advertisement
Table of Contents
