Configuring The Garp Timers - H3C S3600V2 SERIES Layer 2-Lan Switching Configuration Manual

Step
4. Configure the link type of
the ports as trunk.
5. Assign the trunk ports to
all VLANs.
6. Enable GVRP on the
ports.
7. Configure the GVRP
registration mode on the
port.

Configuring the GARP timers

Step
1. Enter system view.
2. Configure the GARP
LeaveAll timer.
3. Enter Ethernet interface view,
Layer 2 aggregate interface
view, or port group view.
4. Configure the Hold timer.
5. Configure the Join timer.
6. Configure the Leave timer.
As shown in
following guidelines to configure GARP timers:
If you want to set a value beyond the value range for a timer, you can change the value range by
•
tuning the value of another related timer.
Command
port link-type trunk
port trunk permit vlan all
gvrp
gvrp registration { fixed | forbidden |
normal }
Command
system-view
garp timer leaveall timer-value
•
•
garp timer hold timer-value
garp timer join timer-value
garp timer leave timer-value
Table 20, the value ranges for GARP timers are dependent on one another; use the
Enter Ethernet interface view or
Layer 2 aggregate interface view:
interface interface-type
interface-number
Enter port group view:
port-group manual
port-group-name
176
Remarks
Access by default.
For more information about the
port link-type trunk command,
see Layer 2—LAN Switching
Command Reference.
By default, a trunk port is
assigned to VLAN 1 only.
For more information about the
port trunk permit vlan all
command, see Layer 2—LAN
Switching Command Reference.
Disabled by default.
Optional.
normal by default.
Remarks
N/A
Optional.
1000 centiseconds by default.
The LeaveAll timer applies to all
ports.
Use either command.
Optional.
10 centiseconds by default.
Optional.
20 centiseconds by default.
Optional.
60 centiseconds by default.