Step
2.
Enter interface view or port
group view.
3.
Enable Digest Snooping on
the interface or port group.
4.
Return to system view.
5.
Enable global Digest
Snooping.
Digest Snooping configuration example
Network requirements
As shown in
these devices are in the same region.
Enable Digest Snooping on the ports of Device A and Device B that connect to Device C, so that the three
devices can communicate with one another.
Figure 25 Digest Snooping configuration
Configuration procedure
# Enable Digest Snooping on Ethernet 1/0/1 of Device A and enable global Digest Snooping on
Device A.
<DeviceA> system-view
[DeviceA] interface ethernet 1/0/1
[DeviceA-Ethernet1/0/1] stp config-digest-snooping
[DeviceA-Ethernet1/0/1] quit
Figure
25, Device A and Device B connect to Device C, which is a third-party device. All
Command
•
Enter Layer 2 Ethernet interface
view or Layer 2 aggregate
interface view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
stp config-digest-snooping
quit
stp config-digest-snooping
94
Remarks
Use either command.
Disabled by default.
N/A
Disabled by default.