Lldp Configuration Examples; Basic Lldp Configuration Example - H3C S3600V2 SERIES Layer 2-Lan Switching Configuration Manual

Task
Display types of advertisable
optional LLDP TLVs.

LLDP configuration examples

Basic LLDP configuration example

Network requirements
As shown in
Switch B are connected to Ethernet 1/0/1 and Ethernet 1/0/2 of Switch A.
Enable LLDP on the ports of Switch A and Switch B to monitor the link between Switch A and Switch B and
the link between Switch A and the MED device on the NMS.
Figure 79 Network diagram
Configuration procedure
Configure Switch A:
1.
# Enable LLDP globally.
<SwitchA> system-view
[SwitchA] lldp enable
# Enable LLDP on Ethernet 1/0/1 and Ethernet 1/0/2. (You can skip this step because LLDP is
enabled on ports by default.) Set the LLDP operating mode to Rx.
[SwitchA] interface ethernet 1/0/1
[SwitchA-Ethernet1/0/1] lldp enable
[SwitchA-Ethernet1/0/1] lldp admin-status rx
[SwitchA-Ethernet1/0/1] quit
[SwitchA] interface ethernet 1/0/2
[SwitchA-Ethernet1/0/2] lldp enable
[SwitchA-Ethernet1/0/2] lldp admin-status rx
[SwitchA-Ethernet1/0/2] quit
Configure Switch B:
2.
# Enable LLDP globally.
<SwitchB> system-view
[SwitchB] lldp enable
Figure 79, the NMS and Switch A are located in the same Ethernet. An MED device and
Command
display lldp tlv-config [ interface interface-type
interface-number ] [ | { begin | exclude | include }
regular-expression ]
238
Remarks
Available in any
view