Configuring The Customer-Side Port; Configuring The Network-Side Port - H3C S3600V2 SERIES Layer 2-Lan Switching Configuration Manual

Step
11. Associate the class with the
behavior.

Configuring the customer-side port

Step
1. Enter system view.
2. Enter interface view or port
group view.
3. Configure the link type of the
port.
4. Assign the port to all SVLANs.
5. Apply the uplink policy
configured for the
customer-side port to
incoming traffic.
6. Apply the downlink policy
configured for the
customer-side port to outgoing
traffic.

Configuring the network-side port

Step
1. Enter system view.
2. Enter interface view or port
group view.
Command
classifier tcl-name behavior
behavior-name
Command
system-view
•
Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
•
Configure the port as a trunk
port:
port link-type trunk
•
Configure the port as a hybrid
port:
port link-type hybrid
•
Assign the trunk port to VLANs:
port trunk permit vlan { vlan-list
| all }
•
Assign the hybrid port to VLANs
as a tagged member:
port hybrid vlan vlan-list
tagged
qos apply policy policy-name
inbound
qos apply policy policy-name
outbound
Command
system-view
•
Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
215
Remarks
Repeat this step to create other
class-behavior associations.
Remarks
N/A
N/A
Use one of the commands.
The default link type of an Ethernet
port is access.
Use one of the commands.
By default:
•
A trunk port is assigned only to
VLAN 1.
•
A hybrid port is an untagged
member of VLAN 1.
N/A
N/A
Remarks
N/A
N/A