Installing With The Oem-Fd For Mass Storage Device - NEC N8400-086F User Manual

Installing with the OEM-FD for Mass Storage Device

This section explains how to setup with the OEM-FD. You usually do not have to do as follows. If
your system has any Mass storage devices, you have to set as follows depending on your system.
The detailed information is provided by the manual of the Mass storage device.
Creating New RAID using RAID Controller
If you create new RAID using RAID Controller, create RAID by following procedure before
installing Windows Server 2008 32bit (x86) Edition.
If you do not need to create new RAID, this procedure is not required.
Case of creating RAID using [EXPRESSBUILDER].
1.
Boot from the EXPRESSBUILDER DVD.
2.
Select [Perform the Express setup] from the Top Menu, click [Next].
3.
When [Load parameters] screen is displayed, if you do not need to load parameters, select
[Do not load parameters] and click [Next].
4.
Select [Install other Operating System] at [Select OS] steps, and then click [Next].
5.
Select [Create a logical drive using the settings that follow] at [Enter RAID settings]
steps.
Confirm the parameters, modify if necessary, and then click [Next].
6.
Save parameters at [Save parameters] steps.
If you do not need to save parameters, select [Do not save parameters], and click [Next].
7.
Click [Perform] at [Configuring RAID] steps.
RAID configuration is started.
8.
When [Exit EXPRESSBUILDER] screen is displayed, click [Perform] again.
The system reboots.
Reboot from EXPRESSBUILDER DVD, and then perform Express Setup referring to
[Installing the Operating System with Express Setup].
NOTE: When you start Express Setup, select [Skip the logical drive
creation] at Step 4 [Enter RAID settings] screen.
Installing the Operating System with Express Setup 5-55