Adjusting The Rear Brake - Yamaha XV1600A1999 Service Manual

ADJUSTING THE REAR BRAKE

EAS00110
ADJUSTING THE REAR BRAKE
1. Measure:
2. Adjust:
a. Loosen the locknut 1 .
b. Turn the adjusting bolt 2 in direction a or b
After adjusting the brake pedal position,
check that the end c of the adjusting bolt is
visible through the hole d .
c. Tighten the locknut 1 to specification.
A soft or spongy feeling in the brake pedal
can indicate the presence of air in the brake
system. Before the vehicle is operated, the
air must be removed by bleeding the brake
system. Air in the brake system will consid-
erably reduce braking performance and
could result in loss of control and possibly
an accident. Therefore, check and, if neces-
sary, bleed the brake system.
After adjusting the brake pedal position,
make sure there is no brake drag.
3. Adjust:
3-32
S brake pedal position
(distance a from the top of the rider footrest
to the top of the brake pedal)
Out of specification ³ Adjust.
Brake pedal position (below the
top of the rider footrest)
100 mm
S brake pedal position
until the specified brake pedal position is ob-
tained.
Direction Brake pedal is raised.
a
Direction Brake pedal is lowered.
b
WARNING
Locknut
18 Nm (1.8 mSkg)
WARNING
CAUTION:
S rear brake light switch
Refer to "ADJUSTING THE REAR BRAKE
LIGHT SWITCH".
CHK
ADJ