STARTER MOTOR
5. Measure:
S brush length a
Out of specification ! Replace the brushes
as a set.
Minimum brush length
5 mm
6. Measure:
S brush spring force
Out of specification ! Replace the brush
springs as a set.
Brush spring force
7.65
(765
7. Check:
S gear teeth
Damage/wear ! Replace the gear.
8. Check:
S bearing
S oil seal
Damage/wear ! Replace the defective
part(-s).
EB803701
ASSEMBLING THE STARTER MOTOR
1. Install:
S starter motor yoke 1
S bush holder 2
2. Install:
S brush seat 1
NOTE:
Align the tab a on the brush seat with the slot b
in the starter motor rear cover.
7-26
ELEC
10.01 Nm
1,001 gf)
E