CHECKING AND TIGHTENING THE SPOKES/
CHECKING AND LUBRICATING THE CABLES
2. Tighten:
S spokes
(with a spoke wrench 1 )
NOTE:
Be sure to tighten the spokes before and after
break-in.
EAS00170
CHECKING
AND
CABLES
The following procedure applies to all of the
cable sheaths and cables.
WARNING
Damaged cable sheaths may cause the
cable to corrode and interfere with its move-
ment. Replace damaged cable sheaths and
cables as soon as possible.
1. Check:
S cable sheath
Damage ! Replace.
2. Check:
S cable operation
Rough movement ! Lubricate.
Recommended lubricant
Engine oil or a suitable cable
lubricant
NOTE:
Hold the cable end upright and pour a few drops
of lubricant into the cable sheath or use a suit-
able lubing device.
3-48
CHK
ADJ
3 Nm (0.3 mSkg)
LUBRICATING
THE