Connecting The Power Supply; Connecting The Power Supply; Voltage Selection - Digital Projection E-Vision Laser 4K Series User Manual

Digital Projection E-Vision Laser 4K Series

Connecting The Power Supply

Adjust the VOLTAGE SELECT switch

Voltage selection

The VOLTAGE SELECT switch must be set to match the power supply you are using:
Voltage of power supply used
AC100-130V outlet
AC200-240V (single phase) outlet
Installation and Quick-Start Guide

CONNECTING THE POWER SUPPLY

to the required voltage, then firmly push the mains connector into the socket
1
1
2
Position of VOLTAGE SELECT switch
2 .
Use only the power cable
provided.
Ensure that the power outlet
includes a ground connection as
this equipment MUST be earthed.
Handle the power cable carefully
and avoid sharp bends. Do not
use a damaged power cable.
Notes
Rev A June 2017
page 4