Power On/Off - Digital Projection E-Vision Laser 4K Series User Manual

Digital Projection E-Vision Laser 4K Series
Setup menu continued from previous page

Power On/Off

•
Auto Power Off
Set this to On if you want the projector to go into STANDBY mode when no input
source is detected for 20 minutes.
•
Auto Power On
Set this to if you want the projector to start up immediately when the mains is
On
connected.
Set this to Off if you want the projector to go into STANDBY mode when the mains
is connected. In this case, the projector will not start up until the
pressed on the control panel or the
•
Scheduled on/off
Access this submenu to create a weekly schedule for automatic on and off times:
1. Set a schedule:
•
Use the and
UP DOWN
to enable edit mode.
ENTER/OK
•
Within a row, navigate with the
values with the UP and
•
To exit edit mode, press
want the changes to take effect. Move to another row using the
arrow buttons.
DOWN
2. To enable the schedule, set Schedule
Operating Guide
POWER
button is pressed on the remote control.
ON
arrow buttons to highlight a row, then press
and arrow buttons. Set
LEFT RIGHT
DOWN arrow buttons.
ENTER/OK . Alternatively, press EXIT
to On .
USING THE PROJECTOR

Power On/Off

Auto Power Off
Auto Power On
Scheduled on/off
button is
Scheduled on/off
Schedule
S M T W T F S
¨ ¨ ¨ ¨ ¨ ¨
T
On
T ¨ ¨ ¨ ¨ ¨ ¨
Off
T ¨ ¨ ¨ ¨ ¨ ¨
On
if you don't
T ¨ ¨ ¨ ¨ ¨ ¨
Off
and
UP
Off
Off
u
Off
Time
12: 34
12: 34
12: 34
12: 34
Notes
Rev A June 2017
page 65