Edid On The Displayport, Hdmi And Hdbaset Inputs; Using Displayport/Hdmi/Hdbaset Switchers With The Projector - Digital Projection E-Vision Laser 4K Series User Manual

Digital Projection E-Vision Laser 4K Series

EDID on the DisplayPort, HDMI and HDBaseT inputs

If you are using a computer graphics card or another source that obeys the EDID protocol, the source will automatically configure itself to suit
the projector.
Otherwise refer to the documentation supplied with the source to manually set the resolution to the DMD™ resolution of the projector or the
nearest suitable setting. Switch off the source, connect to the projector, then switch the source back on again.

Using DisplayPort/HDMI/HDBaseT switchers with the projector

When using a DisplayPort/HDMI/HDBaseT source switcher with the projector, it is important to set the switcher so that it passes the projector
EDID through to the source devices. If this is not done, the projector may not be able to lock to the source or display the source correctly as
its video output timings may not be compatible with those of the projector. Sometimes this is called transparent, pass-through or clone mode.
See your switcher's manual for information on how to set this mode.
Sources
1
Switcher
2
Projector
3
Connection Guide
1 2
EDID
EDID
EDID
The EDIDs in the switcher should be the same as the one in the projector.
SIGNAL INPUTS
3
EDID
Notes
Rev A June 2017
page 22