3D Types - Digital Projection E-Vision Laser 4K Series User Manual

Digital Projection E-Vision Laser 4K Series
3D menu continued from previous page

3D types

In most situations you can use the Auto
help you set up the 3D input manually.
The following 3D formats are supported:
•
Dual Pipe (LEFT and RIGHT)
The left and right eye images are delivered on two separate HDMI links, which the projector will interleave for 3D display.
•
Sequential
Main will accept frame rates up to 160Hz. Lower frame rates can be multiplied for display. An example would be 60Hz (30 frames per eye
in Left-Right sequence (L1, R1, L2, R2...) with
R1, L2, R2, L2, R2...). Sub can accept frame rates up to 60Hz and frame-multiply in a similar manner.
should never be set to result in a displayed frame rate above 160Hz - doing so will result in an image error.
Frame Rate Multiplier
For sequential 3D, an external sync is required to identify left and right frames. If no sync is available from the sequential source, the
projector will generate an output sync, but it may then be necessary to manually reset the dominance each time the player is started.
L
and need to be set only once, to optimize the image for the glasses in use.
Dark Time Sync Delay
Operating Guide
setting to have the projector automatically detect the format. Otherwise, consider the notes below to
L
HDMI 1
R
HDMI 2
Dual Pipe
Frame Rate Multiplier set to 2x, resulting in a displayed sequence at 120Hz (L1, R1, L1,
R L
Sequential
USING THE PROJECTOR
R
Notes
Rev A June 2017
page 59