Selecting An Input Signal; Selecting A Test Pattern - Digital Projection E-Vision Laser 4K Series User Manual

Digital Projection E-Vision Laser 4K Series

Selecting an input signal

1. Connect one or more image sources to the projector.
2. Select the input you want to display:
•
Press one of the input buttons on the remote control.
•
Alternatively, open the On-screen display (OSD) by pressing
select an input signal using the

Selecting a test pattern

To display a test pattern:
•
Press on the remote control.
TEST
Change the test pattern using the
White, Black, Red, Green, Blue, Cyan, Yellow, Magenta, Off
•
Alternatively, open the OSD by pressing
and arrow buttons.
RIGHT
After the final test pattern, the projector exits test pattern mode and returns to the main image. To view test patterns again, you need to press
TEST again. If you wish to exit the test patterns before you reach the final one,
•
press TEST or EXIT at any time.
Installation and Quick-Start Guide
MENU
UP and DOWN arrow buttons. Press
and arrow buttons. Test patterns are displayed in the following order:
LEFT RIGHT
MENU . Highlight Test Patterns
OPERATING THE PROJECTOR
. Highlight from the main menu, press
Input
ENTER/OK to confirm your choice.
from the main menu, then select a test pattern using the
For full details of how to use the
controls and the menu system, see
the Operating
and then
ENTER/OK
LEFT
Notes
Guide.
Rev A June 2017
page 16