Version 9 And Version 10 Templates; Table 9: Template-Set; Table 10: Basic Ipv4 Template - Alcatel-Lucent 7450 Configuration Manual

Version 9 and Version 10 Templates

If the collector is configured to use either version 9 or 10 (IPFIX) formats, the flow data is sent to
the designated collector using one of the pre-defined templates. The template used is based on the
type of flow for which the data was collected (IPv4, IPv6, MPLS or Ethernet (Layer 2)), and the
configuration of the template-set parameter.
values and the corresponding template used to export the flow data.

Table 9: Template-Set

Traffic type
IPv4
IPv6
MPLS
Ethernet
Each flow exported, to a collector configured for either v9 or v10 formats, will be sent using one of
the above flow template sets. As described above, which template is used is based on the flow type
and how the collector's template-set parameter is configured.
The following tables specify the fields present in each template:

Table 10: Basic IPv4 Template

IPv4 Src Addr
IPv4 Dest Addr
IPv4 Nexthop
BGP Nexthop
Ingress Interface
Egress Interface
Packet Count
Byte Count
Start Time
End Time
7450 ESS Router Configuration Guide
Basic
Basic IPv4
Basic IPv6
Basic MPLS
L2-IP
Field Name
8
12
15
18
10
14
2
1
22
21
Configuring System Management with CLI
Table 9 indicates the relationship between these
MPLS-IP
MPLS-IPv4
MPLS-IPv6
MPLS-IP
L2-IP
Field ID
Page 615