Alcatel-Lucent 7450 Configuration Manual page 209

remote-id
Syntax remote-id [mac | string string]
no remote-id
Context config>router>if>dhcp>option
Description When enabled, the router sends the MAC address of the remote end (typically the DHCP client) in the
remote-id suboption of the DHCP packet. This command identifies the host at the other end of the
circuit. If disabled, the remote-id suboption of the DHCP packet will be left empty.
The no form of this command returns the system to the default.
Default remote-id
Parameters mac — This keyword specifies the MAC address of the remote end is encoded in the suboption.
string string — Specifies the remote-id.
vendor-specific-option
Syntax [no] vendor-specific-option
Context config>router>if>dhcp>option
Description
This command configures the Alcatel-Lucent vendor specific suboption of the DHCP relay packet.
client-mac-address
Syntax [no] client-mac-address
Context config>router>if>dhcp>option
Description This command enables the sending of the MAC address in the Alcatel-Lucent vendor specific
suboption of the DHCP relay packet.
The no form of the command disables the sending of the MAC address in the Alcatel-Lucent vendor
specific suboption of the DHCP relay packet.
pool-name
Syntax [no] pool-name
Context config>router>if>dhcp>option>vendor-specific-option
7450 ESS Router Configuration Guide
when the Option 82 bits are stripped, dot1p bits will be copied to the Ethernet header of an
outgoing packet.
IP Router Configuration
Page 209