Alcatel-Lucent 7450 Configuration Manual page 546

MAC Filter Match Criteria
snap-pid
Syntax snap-pid pid-value
no snap-pid
Context config>filter>mac-filter>entry
Description
Configures an IEEE 802.3 LLC SNAP Ethernet Frame PID value to be used as a MAC filter match
criterion.
This is a two-byte protocol id that is part of the IEEE 802.3 LLC SNAP Ethernet Frame that follows
the three-byte OUI field.
The snap-pid field, etype field, ssap and dsap fields are mutually exclusive and may not be part of the
same match criteria.
Note: The snap-pid match criterion is independent of the OUI field within the SNAP header. Two
packets with different three-byte OUI fields but the same PID field will both match the same filter
entry based on a snap-pid match criteria.
The no form of the command removes the snap-pid value as the match criteria.
Default no snap-pid
Parameters pid-value — The two-byte snap-pid value to be used as a match criterion in hexadecimal.
src-mac
Syntax src-mac ieee-address [ieee-address-mask]
no src-mac
Context config>filter>mac-filter>entry
Description
Configures a source MAC address or range to be used as a MAC filter match criterion.
The no form of the command removes the source mac as the match criteria.
Default no src-mac
Parameters ieee-address — Enter the 48-bit IEEE mac address to be used as a match criterion.
ieee-address-mask — This 48-bit mask can be configured using:
Page 546
Values 0x0000 — 0xFFFF
Values HH:HH:HH:HH:HH:HH or HH-HH-HH-HH-HH-HH where H is a hexadecimal
digit
Format Style
Decimal
Hexadecimal
Binary
Format Syntax
DDDDDDDDDDDDDD
0xHHHHHHHHHHHH
0bBBBBBBB...B
7450 ESS Router Configuration Guide
Example
281474959933440
0x0FFFFF000000
0b11110000...B