Common Configuration Tasks; Configuring A System Name - Alcatel-Lucent 7450 Configuration Manual

Common Configuration Tasks

Common Configuration Tasks

The following sections describe basic system tasks.
•
•
•
•
•
•

Configuring a System Name

Use the
string. Only one system name can be configured. If multiple system names are configured, the last
one configured will overwrite the previous entry.
If special characters are included in the system name string, such as spaces, #, or ?, the entire string
must be enclosed in double quotes. Use the following CLI syntax to configure the system name:
CLI Syntax: config# system
Example
The following example displays the system name output.
A:ALA-A>config>system# info
#------------------------------------------
# System Configuration
#------------------------------------------
Page 78
Configuring a System Name on page 78
Configuring Interfaces on page 79
→
Configuring a System Interface on page 79
→
Configuring a Network Interface on page 79
Configuring Proxy ARP on page 84
Creating an IP Address Range on page 87
Configuring an Autonomous System on page 90
Configuring Overload State on a Single SFM on page 91
command to configure a name for the device. The name is used in the prompt
system
name system-name
:
config# system
config>system# name ALA-A
ALA-A>config>system# exit all
ALA-A#
name "ALA-A"
location "Mt.View, CA, NE corner of FERG 1 Building"
coordinates "37.390, -122.05500 degrees lat."
snmp
exit
7450 ESS Router Configuration Guide