Alcatel-Lucent 7450 Configuration Manual page 151

destruct-timeout
Syntax destruct-timeout destruct-timeout
no destruct-timeout
Context config>router>l2tp>group
config>router>l2tp>group>tunnel
Description This command configures the period of time that the data of a disconnected tunnel will persist before
being removed.
The no form of the command removes the value from the configuration.
Default no destruct-timeout
Parameters
destruct-timeout — [Specifies the automatic removal of dynamic L2TP sessions, in seconds, that are
hello-interval
Syntax hello-interval hello-interval
no hello-interval
Context config>router>l2tp>group
Description This command configures the time interval between two consecutive tunnel Hello messages. The
Hello message is an L2TP control message sent by either peer of a LAC-LNS control connection.
This control message is used as a keepalive for the tunnel.
The no form of the command removes the interval from the configuration.
Default
60
Parameters hello-interval — Specifies the time interval, in seconds, between two consecutive tunnel Hello
idle-timeout
Syntax idle-timeout idle-timeout
no idle-timeout
Context config>router>l2tp>group
Description This command configures the period of time that an established tunnel with no active sessions will
persist before being disconnected.
7450 ESS Router Configuration Guide
no longer active.
Default
no destruct-timeout
Values 60 — 86400
messages.
Default no hello-interval
Values
60 — 3600
IP Router Configuration
Page 151