Alcatel-Lucent 7450 Configuration Manual page 552

Redirect Policy Commands
Description
Specifies the amount of time, in seconds, that is allowed for receiving a response from the far-end
host. If a reply is not received within this time the far-end host is considered unresponsive.
Default 1
Parameters seconds — Specifies the amount of time, in seconds, that is allowed for receiving a response from the
priority
Syntax priority priority
no priority
Context config>filter>destination
Description Redirect policies can contain multiple destinations. Each destination is assigned an initial or base
priority which describes its relative importance within the policy.
Default 100
Parameters
priority — The priority, expressed as a decimal integer, used to weigh the destination's relative
snmp-test
Syntax snmp-test test-name
Context config>filter>redirect-policy>destination
Description This command enables the context to configure SNMP test parameters.
Default none
Parameters
test-name — specifies the name of the SNMP test. Allowed values are any string up to 32 characters
oid
Syntax oid oid-string community community-string
Context config>filter>redirect-policy>destination>snmp-test
Description
This command specifies the OID of the object to be fetched from the destination.
Page 552
far end host.
Values 1 — 60
importance within the policy.
Values
1 — 255
long composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
7450 ESS Router Configuration Guide