Alcatel-Lucent 7450 Configuration Manual page 244

Show Commands
Parameters
ip-address — Only displays the interface information associated with the specified IP address.
ip-int-name — Only displays the interface information associated with the specified IP interface name.
detail — Displays detailed IP interface information.
statistics — Displays packet statistics for an interface on the router.
Note: The show router interface statistics command also shows the MPLS statistics that are shown in
using the show router mpls interface statistics command. This allows the operator to see MPLS
statistics from interfaces that are not added to MPLS, such as a carrier's network interfaces. See
"Sample Output" on page 253 for an example of the MPLS fields that are displayed. These fields are
displayed regardless of the state of MPLS.
summary — Displays summary IP interface information for the router.
exclude-services — Displays IP interface information, excluding IP interfaces configured for customer
family — Specifies the router IP interface family to display.
Output Standard IP Interface Output — The following table describes the standard output fields for an IP
interface.
Interface-Name
Type
IP-Address
Adm
Opr
Mode
Page 244
Values ipv4-address
ipv6-address
services. Only core network IP interfaces are displayed.
Values ipv4 — Displays only those peers that have the IPv4 family enabled.
Values ipv6 — Displays the peers that are IPv6-capable.
Label
The IP interface name.
n/a — No IP address has been assigned to the IP interface, so the IP
address type is not applicable.
Pri — The IP address for the IP interface is the Primary address on
the IP interface.
Sec — The IP address for the IP interface is a secondary address on
the IP interface.
The IP address and subnet mask length of the IP interface.
n/a
Down — The IP interface is administratively disabled.
Up — The IP interface is administratively enabled.
Down — The IP interface is operationally disabled.
Up — The IP interface is operationally disabled.
Network — The IP interface is a network/core IP interface.
Service — The IP interface is a service IP interface.
a.b.c.d (host bits must be 0)
x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
Description
— Indicates no IP address has been assigned to the IP interface.
7450 ESS Router Configuration Guide