Debug Commands - Alcatel-Lucent 7450 Configuration Manual

Show Commands
interval — Configures the interval for each display in seconds.
repeat repeat — Configures how many times the command is repeated.
absolute — When the absolute keyword is specified, the raw statistics are displayed, without pro-
cessing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead

Debug Commands

cpm
Syntax cpm
Context tools>dump>filter>resources
Description
This command displays information about filter resource utilization on the CPM, consumption by
filter-using services like TMS, Flowspec, OpenFlow, and the filters that use the most resources.
Sample Output
*A:Dut-C>tools>dump>filter>resources># cpm
===========================================================================
Number of ACL filters defined on CPM
===========================================================================
Owner
---------------------------------------------------------------------------
Configuration
BGP FlowSpec
Host Common
Tms
Openflow
---------------------------------------------------------------------------
Total
===========================================================================
Available filters (except openflow): 16369
Available openflow filters:
=============================================================================
Number of ACL filter entries / subentries defined on CPM
=============================================================================
Inserted by
-----------------------------------------------------------------------------
Page 588
Default 5 seconds
Values 3 — 60
Default
10
Values 1 — 999
of the delta.
MAC IP
0 7
0 2
0 2
0 1
0 2
0 14
16381
MAC
7450 ESS Router Configuration Guide
IPv6 Total
0
2
0
1
1
4
IP IPv6 Total
7
4
2
2
3
18