Alcatel-Lucent 7450 Configuration Manual page 69

Hide thumbs Also See for 7450:
Table of Contents

Advertisement

Assume now the aggregate-prefix-match was enabled and that LDP found a /16 prefix in RTM to
activate the FEC for the /24 FEC prefix. In this case, RTM adds a new more specific route entry of
/24 and has the next-hop as the LDP LSP but it will still not have a specific /24 IP route entry.
RTM then resolves all user prefixes which succeed a longest prefix match against the /24 route
entry to use the LDP LSP while all other prefixes which succeed a longest prefix-match against the
/16 route entry will use the IP next-hop. LDP shortcut will also work when using RIP for routing.
LDP Shortcut Forwarding Plane
Once LDP activated a FEC for a given prefix and programmed RTM, it also programs the ingress
Tunnel Table in IOM with the LDP tunnel information.
When an IPv4 packet is received on an ingress network interface, a subscriber IES interface, or a
regular IES interface, the lookup of the packet by the ingress IOM will result in the packet being
sent labeled with the label stack corresponding to the NHLFE of the LDP LSP when the preferred
RTM entry corresponds to an LDP shortcut.
If the preferred RTM entry corresponds to an IP next-hop, the IPv4 packet is forwarded unlabelled.
The switching from the LDP shortcut next-hop to the regular IP next-hop when the LDP FEC
becomes unavailable depends on whether the next-hop is still available. If it is (for example, the
LDP FEC was withdrawn due to LDP control plane issues) the switchover should be faster. If the
next-hop determination requires IGP to re-converge, this will take longer. However no target is set.
The switching from a regular IP next-hop to an LDP shortcut next-hop will normally occur only
when both are available. However, the programming of the NHLFE by LDP and the programming
of the LDP tunnel information in the ingress IOM tunnel table are asynchronous. If Tunnel Table
is configured first, it is possible that traffic will be black holed for some time .
ECMP Considerations
When ECMP is enabled and multiple equal-cost next-hops exit for the IGP route, the ingress IOM
will spray the packets for this route based on hashing routine currently supported for IPv4 packets.
When the preferred RTM entry corresponds to an LDP shortcut route, spraying will be performed
across the multiple next-hops for the LDP FEC. The FEC next-hops can either be direct link LDP
neighbors or T-LDP neighbors reachable over RSVP LSPs in the case of LDP-over-RSVP but not
both. This is as per ECMP for LDP in existing implementation.
When the preferred RTM entry corresponds to a regular IP route, spraying will be performed
across regular IP next-hops for the prefix.
Spraying across regular IP next-hops and LDP-shortcut next-hops concurrently is not supported.
7450 ESS Router Configuration Guide
IP Router Configuration
Page 69

Advertisement

Table of Contents
loading

Table of Contents