13
WIRING HARNESS, BATTERY
13.1
Removing the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
13.2
Installing the battery
Preparatory work
–
Remove the passenger seat. (
–
Remove the seat. (
Main work
–
Pull back the negative terminal cover
–
Disconnect the negative cable
B00750-10
–
Pull back the positive terminal cover
–
Disconnect the positive cable
–
Detach rubber band
–
Pull the battery up and out of the battery holder.
Info
Never operate the motorcycle with a discharged battery or without a battery.
In both cases, electrical components and safety devices can be damaged.
The vehicle is therefore no longer roadworthy.
B00751-10
Main work
–
Position the battery in the battery holder.
Info
The battery terminals must be at the top.
–
Attach rubber band
–
Reconnect the positive cable
–
Position positive terminal cover
B00751-11
–
Connect the negative cable
–
Position the negative terminal cover
B00750-11
Finishing work
–
Mount the seat. (
–
Mount the passenger seat. (
–
Set the clock. (
p. 39)
p. 38)
.
1
of the battery.
2
.
3
of the battery.
4
.
5
.
1
of the battery.
2
.
3
of the battery.
4
.
5
p. 39)
p. 39)
p. 77)
62