16
ENGINE
16.3.44 Removing the cylinder head (200 Duke)
16.3.45 Removing the piston (200 Duke)
–
Remove screws
305825-10
–
Release screws
–
Take off the cylinder head.
305826-10
–
Take off the cylinder head gasket
–
Remove dowels
305827-10
–
Remove timing chain guide rail
305828-10
–
Push the cylinder upward.
Info
Push the cylinder upward only far enough to allow removal of the piston pin.
–
Remove piston pin retainer
–
Remove the piston pin.
–
Take off the cylinder with the piston.
–
Push the piston upward out of the cylinder.
305830-10
Info
If no other work is required on the cylinder and the piston, you can leave the
piston in the cylinder.
.
1
in a crisscross pattern and remove them with the washers.
2
.
3
.
4
.
5
.
1
108