8
SHOCK ABSORBER, SWINGARM
8.4
Removing the spring
8.5
Installing the spring
–
Lift the link fork.
–
Mount and tighten screw
Guideline
Screw, top shock absorber
–
Tighten fitting
Guideline
Fitting, bottom shock absorber
304841-11
Finishing work
–
Remove the motorcycle from the work stand. (
Condition
The shock absorber has been removed.
–
Clamp the shock absorber in the vise using soft jaws for protection.
–
Note the position of the spring preload.
–
Loosen adjusting ring
Hook wrench (T106S) (
201698-10
–
Clamp the shock absorber into the special tool.
Spring compressor (T14050S) (
Info
Use the ring of the special tool with the smallest possible inside diameter. It
must be pressed directly onto the spring.
–
Compress the spring.
–
Remove spring retainer
201697-10
–
Release the spring. Remove the shock absorber from the special tool.
–
Remove the spring.
–
Mount the spring.
The tight coil of the spring is at the bottom.
–
Clamp the shock absorber into the special tool.
Spring compressor (T14050S) (
Info
Use the ring of the special tool with the smallest possible inside diameter. It
must be pressed directly onto the spring.
201697-10
–
Mount spring retainer
The open end is opposite the spring end.
–
Release the spring. Remove the shock absorber from the special tool.
–
Clamp the shock absorber in the vise using soft jaws for protection.
.
3
.
2
using the special tool.
A
p. 259)
p. 260)
.
1
p. 260)
.
1
M10x1.25
50 Nm
(36.9 lbf ft)
M10x1.25
45 Nm
(33.2 lbf ft)
p. 12)
31