Mounting The Seat; Removing The Passenger Seat; Mounting The Passenger Seat; Removing The Fuel Tank Cover - KTM 125 DUKE EU Repair Manual

11 FUEL TANK, SEAT, TRIM
11.4

Mounting the seat

11.5

Removing the passenger seat

11.6

Mounting the passenger seat

11.7

Removing the fuel tank cover

Danger
Fire hazard Fuel is highly flammable.
–
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
The fuel in the fuel tank expands when warm and may emerge if overfilled. Follow the instructions on refueling.
Main work
–
Attach seat recesses
–
Mount and tighten screws
Guideline
Screw, seat
B00727-10
Finishing work
–
Mount the passenger seat. (
–
Insert the ignition key in seat lock
–
Raise the rear of the seat, push it towards the rear, and remove it upwards.
–
Remove the ignition key from the seat lock.
B00712-01
–
Attach hooks
at the rear while pushing forward.
–
Press down the passenger seat until it clicks into place.
Warning
Danger of accidents The passenger seat can come loose from the anchoring
if it is not mounted correctly.
–
B00724-10
–
Finally, check that the passenger seat is correctly mounted.
at screws and lower at the rear.
A 1
.
2
p. 39)
and turn it clockwise.
1
on the passenger seat to brackets
1
After mounting the passenger seat, check that it is locked correctly by
pulling up.
M6 11 Nm (8.1 lbf ft)
on the subframe, and lower it
2
39