6
FORK, TRIPLE CLAMP
6.10
Adjusting the steering head bearing play
»
If click positions are noticeable:
–
Adjust the play of the steering head bearing. (
–
Check the steering head bearing and change if necessary.
Finishing work
–
Remove the motorcycle from the work stand. (
Preparatory work
–
Raise the motorcycle with the work stand. (
Main work
–
Loosen screws
–
Loosen screw
304855-10
–
Tighten nut
ing.
Key for steering head bearing (90129051000) (
304856-10
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Tighten screw
Guideline
Screw, top steering head
–
Tighten screw
Guideline
Screw, top triple clamp
304855-10
Finishing work
–
Check the steering head bearing play. (
–
Remove the motorcycle from the work stand. (
.
1
.
2
with the special tool until there is no play in the steering head bear-
3
.
2
.
1
p. 27)
p. 12)
p. 11)
p. 259)
M16x1.5
52 Nm
(38.4 lbf ft)
M8
11 Nm (8.1 lbf ft)
p. 26)
p. 12)
27