Removing The Engine From The Engine Assembly Stand (125 Duke); Installing The Crankshaft (200 Duke); Installing The Balancer Shaft (200 Duke) - KTM 125 DUKE EU Repair Manual

16 ENGINE

16.5.34 Removing the engine from the engine assembly stand (125 Duke)

16.5.35 Installing the crankshaft (200 Duke)

16.5.36 Installing the balancer shaft (200 Duke)

–
Mount and tighten oil drain plug
Guideline
Oil drain plug
304420-11
–
Remove the fitting from special tools
Engine fixing arm (90129002060) (
Engine fixing arm (90129002050) (
–
Remove the engine from the engine assembly stand.
Info
Have an assistant help you or use a crane.
304417-10
–
Warm the engine case section in an oven.
Guideline
150 °C (302 °F)
–
Mount main bearing
304801-10
–
Heat the main bearing.
Guideline
150 °C (302 °F)
–
Slide crankshaft
–
Heat the left main bearing.
Guideline
150 °C (302 °F)
–
Mount the main bearing on the crankshaft.
305898-10
–
Cool the main bearing.
–
Oil the bearing.
–
Mount special tool
Mounting sleeve (90129005000) (
304503-10
with the O-ring.
2
M24x1.5
and
1
p. 256)
p. 255)
.
1
into the bearing seat.
2
.
1
p. 256)
15 Nm
(11.1 lbf ft)
.
2
175