Storage; Preparing For Use After Storage - KTM 125 DUKE EU Repair Manual

23

STORAGE

23.1 Storage
Info
If you want to garage the motorcycle for a longer period, take the following steps.
Before storing the motorcycle, check all parts for function and wear. If service, repairs or replacements are necessary, you
should do this during the storage period (less workshop overload). In this way, you can avoid long workshop waiting times at the
start of the new season.
23.2

Preparing for use after storage

–
When refueling for the last time before taking the motorcycle out of service, add
fuel additive.
Fuel additive (
–
Refuel.
–
Clean the motorcycle. (
–
Change the engine oil and oil filter, clean the oil screen. (
–
Check the antifreeze and coolant level. (
–
Check the tire air pressure. (
401058-01
–
Remove the battery. (
–
Recharge the battery. (
Guideline
Storage temperature of battery without
direct sunlight
–
Store the vehicle in a dry location that is not subject to large fluctuations in tem-
perature.
Info
KTM recommends jacking up the motorcycle.
–
Raise the motorcycle with the rear wheel stand. (
–
Raise the motorcycle with the front wheel stand. (
–
Cover the motorcycle with a tarp or similar cover that is permeable to air.
Info
Do not use non-porous materials since they prevent humidity from escaping,
thus causing corrosion.
Avoid running the engine for a short time only. Since the engine cannot
warm up properly, the water vapor produced during combustion condenses
and causes valves and exhaust system to rust.
–
Take the motorcycle off of the front wheel stand. (
–
Take the motorcycle off of the rear wheel stand. (
–
Recharge the battery. (
–
Install the battery. (
–
Set the clock. (
–
Refuel.
–
Perform checks and maintenance steps when preparing for use.
–
Take a test ride.
401059-01
p. 250)
p. 211)
p. 195)
p. 53)
p. 62)
p. 63)
0... 35 °C (32... 95 °F)
p. 63)
p. 62)
p. 77)
p. 200)
p. 10)
p. 10)
p. 11)
p. 10)
213