Installing The Ptt Unit (Et) - Yamaha E115A Service Manual

Installing the PTT unit (ET)

1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1.
1
w
9 When installing the PTT unit without
removing the power unit, be sure to sus-
pend the outboard motor. Otherwise, the
outboard motor could suddenly fall and
result in injury.
9 After tilting the outboard motor up, be
sure to support it with the tilt stop lever.
2. Lift the PTT unit up, install the lower
mounting shaft 2 and then tighten the
bolts 3.
3. Install the tilt ram upper end into the swiv-
el bracket with the pin 4 and circlip 5.
4. Tighten the self-locking nut 6 to the
specified torque.
Self-locking nut 6:
15 N·m (1.5 kgf·m, 11.1 ft·lb)
5. Install the anode 7.
6. Pass the PTT motor lead 8 through the
hole of the port clamp bracket.
61U5H11
7. Fasten the PTT motor lead and trim sen-
sor lead with the lock ties 9.
4
8
9
6G470720
3
8. Inject grease into all grease nipples until
grease comes out from the bushings a.
Clamp bracket and swivel bracket
3
2
7
a
1
1
6
5
2
3
4
61U70280
5
6
7
8
6G470770
9
7-32