Yamaha E115A Service Manual page 157

2. Set the gear shift to the neutral position
at the lower unit. Make sure that the shift
rod is in the neutral position using a spe-
cial service tool.
Shift rod push arm:
90890-06052
3. Install the 2 dowels 1 into the lower unit
and extension 2 (E115A: Y-transom).
4. Connect the speedometer hose 3.
5. Install the lower unit into the upper case,
and then tighten the lower case mount
bolts 4 or nuts to the specified torque.
6. Install the trim tab 5 to its original posi-
tion, and then tighten the trim tab bolt 6
to the specified torque.
7
6
3
1
1
4
4
å E115A: Y-transom
Lower case mount bolt (nut) 4:
39 N·m (3.9 kgf·m, 28.8 ft·lb)
Trim tab bolt 6:
39 N·m (3.9 kgf·m, 28.8 ft·lb)
61U5H11
69D60036
1
å
1
1
2
1
4
5
6G460270
Drive shaft and lower case
7. Install the grommet 7.
8. Install the propeller and propeller nut 8,
and then temporarily tighten the nut.
Place a block of wood between the anti-
cavitation plate and propeller to prevent
the propeller from turning, and then tight-
en the nut to the specified torque.
w
9 Do not hold the propeller with your
hands when loosening or tightening it.
9 Be sure to disconnect the battery cables
from the battery and remove the lock
plate from the engine stop lanyard
switch.
9 Put a block of wood between the anti-
cavitation plate and propeller to prevent
the propeller from turning.
NOTE:
If the grooves in the propeller nut 8 do not
align with the propeller shaft hole, tighten the
nut until they are aligned.
Propeller nut 8:
54 N·m (5.4 kgf·m, 39.8 ft·lb)
1
2
3
8
4
5
6
6F660420
7
8
9
6-20