Table of Contents
Advertisement
2
9
cC
9 Make sure that the tilt ram is fully
extended when installing it.
9 Once installed, never push the tilt ram
down, otherwise fluid can spurt out.
Trim and tilt wrench 2:
90890-06587
Tilt cylinder end screw 9:
127 N·m (12.7 kgf·m, 93.7 ft·lb)
11. Install the joint 0 and gear pump filter q
into the gear pump housing.
12. Fill the gear pump housing with the rec-
ommended fluid to the correct level as
shown.
61U5H11
13. Remove all of the air bubble using a
NOTE:
Turn the joint with a screwdriver to bleed the
gear pump.
14. Install a new O-ring w and the PTT motor
6G470650
NOTE:
Align the armature shaft with the recess in the
joint.
q
15. Remove the reservoir cap, and then
0
NOTE:
If the fluid is at the correct level, the fluid
should overflow out of the filler hole when the
reservoir cap is removed.
6G470660
16. If necessary, add sufficient fluid of the
17. Install the reservoir cap, and then tighten
18. Bleed the PTT unit.
19. Check the hydraulic pressure of the PTT
6G470670
Tilt cylinder and trim cylinder
syringe or suitable tool.
e, and then tighten the bolts r to the
specified torque.
PTT motor mount bolt r:
5 N·m (0.5 kgf·m, 3.7 ft·lb)
check the fluid level in the reservoir.
recommended type until it overflows out
of the filler hole.
it to the specified torque.
Reservoir cap:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
unit.
1
2
r
e
3
w
4
6G470680
5
6
7
8
9
7-54
Advertisement
Chapters
Table of Contents
