Yamaha E115A Service Manual page 220

BRKT
4. Install the trim piston assemblies into the
trim cylinders, and then tighten the trim
cylinder end screws to the specified
torque.
2
3
cC
9 Make sure that the trim rams are fully
extended when installing them.
9 Once installed, never push the trim rams
down, otherwise fluid can spurt out.
Trim and tilt wrench 2:
90890-06587
Trim cylinder end screw 3:
132 N·m (13.2 kgf·m, 97.4 ft·lb)
5. Install the new O-rings 4, valve pin 5,
and valve seat assembly 6 onto the tilt
cylinder.
NOTE:
Refer to the illustration for valve pin and valve
seat assembly installation.
6. Install the gear pump housing 7 with the
bolts 8.
4
5
8
7-53
Bracket unit
6G470525
6
4
7
8
8
61U70600
Gear pump housing mounting bolt 8:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
7. Install the O-ring into the reservoir cap.
8. Install the reservoir and new O-ring onto
the gear pump housing.
Reservoir tank mounting bolt:
5 N·m (0.5 kgf·m, 3.7 ft·lb)
9. Fill the tilt cylinder with the recommended
fluid to the correct level through the hole
e as shown.
10. Install the tilt piston assembly into the tilt
cylinder, and then tighten the tilt cylinder
end screw 9 to the specified torque.
e
6G470630
6G470640
61U5H11