Lower Unit; Checking The Tilt Operation (Mh, Wh, E); Checking The Gear Oil Level - Yamaha E115A Service Manual

CHK
ADJ
3. If necessary, add sufficient fluid of the
recommended type until it overflows out
of the filler hole.
Recommended PTT fluid:
ATF Dexron 2
4. Install the new O-ring, reservoir cap 2,
and then tighten it to the specified torque.
Reservoir cap 2:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
Checking the tilt operation
(MH, WH, E)
1. Set the tilt lock lever 1 to tilt position.
Check the outboard motor could tilting
up. Fully tilt the outboard motor up and
down a few times and check the entire tilt
range for smooth operation.
1
2. Fully tilt the outboard motor down and set
the tilt lock lever 1 to lock position.
Check the outboard motor could not tilt-
ing up.
3-11
Periodic check and adjustment
61U30290
1
61U30295
3. Fully tilt the outboard motor up, then sup-
port it with the tilt stop lever 2 to check
the lock mechanism of the lever.

Lower unit

Checking the gear oil level

1. Fully tilt the outboard motor down.
2. Remove the check screw 1, and then
check the gear oil level in the lower case.
NOTE:
If the fluid is at the correct level, the fluid
should overflow out of the filler hole when the
check screw is removed.
3. If necessary, add sufficient gear oil of the
recommended type until it overflows out
of the check hole.
Recommended gear oil:
Hypoid gear oil
API: GL-4
SAE: 90
4. Install the new gasket, check screw 1,
and then tighten it to the specified torque.
Check screw 1:
9 N·m (0.9 kgf·m, 6.6 ft·lb)
2
69D30135
1
69D10055
61U5H11