Installing The Power Unit - Yamaha F15B Service Manual

POWR
18. Install the fuel system. Refer to "Fuel sys-
tem" in the chapter 4.
19. Install the new O-ring, relief valve and oil
strainer assembly.
Relief valve:
8 N·m (0.8 kgf·m, 5.8 ft·lb)

Installing the power unit

1. Clean the power unit matching surface,
and install the dowel pins 1 and the new
gasket 2.
2. Install the power unit 3 by installing the
bolts 4, then tightening them to the
specified torque.
4
Mounting bolt 4:
21 N·m (2.1 kgf·m, 16 ft·lb)
3. Connect the pilot water hose, charge coil
leads, CDI unit leads, ignition coil leads,
pulser coil leads, rectifier regulator leads,
lighting coil leads and engine stop lan-
yard switch leads.
5-49
Power unit
3
1
2
6D451510
4. Install the throttle cable 5 (Pull side) to
the pully 6.
NOTE:
Be sure the throttle grip is in the fully close
position when installing the throttle cables.
5. Turn the pully 6 clockwise until lightly
stop position a, then adjust the throttle
cable by adjusting nut 7. Tighten the
locknut.
6
6. Install the throttle cable 8 (Push side) to
the pully 6.
7. Turn the pully clockwise until lightly stop
position b, then adjust the throttle cable
by adjusting nut 9. Tighten the locknut.
6
a
5
7
6D451520
b
9
8
6D451530
6D45F11