Table of Contents
Advertisement
Step 5.
Slide the server into the rack.
Step 6.
Reconnect the power cords and all external cables, and turn on the server and peripheral devices.
Removing the PCI riser filler
Use this information to remove the PCI riser filler.
To remove the PCI riser filler, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines"
on page 89.
Step 2.
Turn off the compute node and peripheral devices and disconnect the power cords and all external
cables (see "Turning off the compute node" on page 15).
Step 3.
Remove the cover (see "Removing the compute node cover" on page 105).
Step 4.
Grasp the PCI riser filler and lift the PCI riser filler up.
Figure 31. PCI riser filler removal
Step 5.
Remove the PCI riser filler from the compute node and set it aside.
Attention: For proper cooling and airflow, replace the PCI riser filler before you turn on the
compute node. Operating the compute node with the PCI riser filler removed might damage
compute node components.
Replacing the PCI riser filler
Use this information to install the PCI riser filler.
To install the PCI riser filler, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines"
on page 89.
Step 2.
Turn off the compute node and peripheral devices and disconnect the power cords and all external
cables.
Step 3.
Remove the cover (see "Removing the compute node cover" on page 105).
Step 4.
Align the PCI riser filler pin with the baffle pin hole on the right side of the chassis; then, lower the
PCI riser filler into the compute node. Press the PCI riser filler down until it is securely seated.
112
IBM NeXtScale nx360 M4 Installation and Service Guide
PCI riser filler
Advertisement
Table of Contents
Troubleshooting
