Table of Contents
Advertisement
Rear PCI riser
assembly
Figure 90. GPU adapter installation (with rear PCI riser assembly)
Attention: When you install an adapter/GPU adapter, make sure that the adapter/GPU adapter is
correctly seated in the riser-cage assembly and that the riser-cage assembly is securely seated in
the riser-cage connector on the system board before you turn on the server. An incorrectly seated
adapter might cause damage to the system board, the riser-cage assembly, or the adapter/GPU
adapter.
Step 6.
Install the PCI riser-cage assembly in the server (see "Replacing a PCI riser-cage assembly" on
page 152).
Step 7.
Connect the cable to the newly-installed adapter/GPU adapter.
Step 8.
Perform any configuration tasks that are required for the adapter/GPU adapter.
Step 9.
Reinstall the cover (see "Installing the compute node cover" on page 107).
Step 10. Slide the server into the rack.
Step 11. Reconnect the power cords and any cables that you removed.
Step 12. Turn on the peripheral devices and the server.
Removing the USB flash drive
Use this information to remove the USB flash drive.
Before you remove the USB flash drive, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 89.
2. If the compute node is installed in an IBM NeXtScale n1200 Enclosure, remove it (see "Removing a
compute node from a chassis" on page 92 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with
the bezel pointing toward you.
To remove the USB flash drive, complete the following steps.
Power connectors
GPU adapter
.
Chapter 5
Removing and replacing components
159
Advertisement
Table of Contents
Troubleshooting
