Lenovo NeXtScale nx360 M4 Installation And Service Manual page 214

User Response
Complete the following steps until the problem is solved:
1. Reconfigure the watchdog timer to a higher value.
2. Make sure that the IMM Ethernet-over-USB interface is enabled.
3. Reinstall the RNDIS or cdc_ether device driver for the operating system.
4. Disable the watchdog.
5. Check the integrity of the installed operating system.
• 40000028-00000000 : Management Controller Test Alert Generated by [arg1].
This message is for the use case where a user has generated a Test Alert.
May also be shown as 4000002800000000 or 0x4000002800000000
Severity
Info
Serviceable
No
Automatically notify support
No
Alert Category
System - other
SNMP Trap ID
22
CIM Information
Prefix: IMM ID: 0040
User Response
Information only; no action is required.
• 40000029-00000000 : Security: Userid: [arg1] had [arg2] login failures from an SSH client at IP
address [arg3].
This message is for the use case where a user has failed to log in to a Management Controller from SSH.
May also be shown as 4000002900000000 or 0x4000002900000000
Severity
Info
Serviceable
No
Automatically notify support
No
Alert Category
System - Remote Login
200
IBM NeXtScale nx360 M4 Installation and Service Guide