Table of Contents
Advertisement
Screws
Figure 60. Installing a 3.5-inch hard disk drive hardware RAID cage
Step 1.
Remove the cover (see "Removing the compute node cover" on page 105).
Step 2.
Position the hardware RAID cage in the bezel at an angle and rotate the cage into position on the
system board.
Step 3.
Align the cage with the screw holes on the system board.
Step 4.
Using a Phillips screwdriver, insert the 4 screws and secure the cage in the compute node.
Step 5.
Install the easy-swap hard disk drive #7 (see "Installing a 3.5-inch hard disk drive" on page 143).
Step 6.
Connect the power cable and the mini-SAS cable on the system-board and the storage tray
respectively (see "Cabling hard disk drive with ServeRAID SAS/SATA controller" on page 176).
138
IBM NeXtScale nx360 M4 Installation and Service Guide
3.5-inch Hard disk
drive cage
Advertisement
Table of Contents
Troubleshooting
