Removing A Gpu Tray From A Compute Node - Lenovo NeXtScale nx360 M4 Installation And Service Manual

Figure 20. Storage tray installation
Step 5. Hold the front of the compute node and slide the storage tray forward to the closed position,
until it clicks into place.

Removing a GPU tray from a compute node

Use this information to remove a GPU tray from a NeXtScale nx360 M4 compute node.
Before you remove a GPU tray from a compute node, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 89.
2. If the compute node is operating, shut down the operating system.
3. Press the power button to turn off the compute node (see "Turning off the compute node" on page 15
for more information).
To remove the GPU tray from a compute node, complete the following steps:
Step 1. Remove the cover (see "Removing the compute node cover" on page 105).
Step 2. Remove the PCI riser-cage assembly in the GPU tray (see "Removing a PCI riser-cage assembly in
the GPU tray" on page 153).
Step 3. Press on the release latch and slide the GPU tray toward the rear of the compute node.
.
Chapter 5 Removing and replacing components
103