Configuring Device Types For Zone Members; Removing Smart Zoning Configuration - Cisco MDS 9000 Series Configuration Manual

Configuring Device Types for Zone Members

--------------------------------------------------------------------------
FCID TYPE PWWN (VENDOR) FC4-TYPE:FEATURE
--------------------------------------------------------------------------
0x9c0000 N 21:00:00:e0:8b:08:96:22 (Company 1) scsi-fcp:init
0x9c0100 N 10:00:00:05:30:00:59:1f (Company 2) ipfc
0x9c0200 N 21:00:00:e0:8b:07:91:36 (Company 3) scsi-fcp:init
0x9c03d6 NL 21:00:00:20:37:46:78:97 (Company 4) scsi-fcp:target
Configuring Device Types for Zone Members
To configure the device types for zone members, follow these step:
Step 1
switch# configure terminal
Enters configuration mode.
Step 2 switch(config-zoneset-zone)# member device-alias name both
Configures the device type for the device-alias member as both. For every supported member-type, init, target, and both
are supported.
Step 3
switch(config-zoneset-zone)# member pwwn number target
Configures the device type for the pwwn member as target. For every supported member-type, init, target, and both are
supported.
Step 4
switch(config-zoneset-zone)# member fcid number
Configures the device type for the FCID member. There is no specific device type that is configured. For every supported
member-type, init, target, and both are supported.
When there is no specific device type configured for a zone member, at the backend, zone entries that are
Note
generated are created as device type both.

Removing Smart Zoning Configuration

To remove the smart zoning configuration, follow this steps:
Step 1
switch(config)# clear zone smart-zoning fcalias name alias-name vsan number
Removes the device type configuration for all the members of the specified fcalias.
Step 2 switch(config)# clear zone smart-zoning zone name zone name vsan number
Removes the device type configuration for all the members of the specified zone.
Step 3 switch(config)# clear zone smart-zoning zoneset name zoneset name vsan number
Removes the device type configuration for all the members of the zone and fcalias for the specified zoneset.
Step 4
switch(config)# clear zone smart-zoning vsan number
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
98
Configuring and Managing Zones