Remove Dual-Sided Digital Clock From Mounting Bracket; Flush-Mount Installation - Primex XR Classic Series Installation Manual

Figure 21: Dual-Sided Digital Clock Dimension (C)

Remove Dual-Sided Digital Clock from Mounting Bracket

2.5" x 4 and 2.5" x 6: From the top of the bracket, using a screwdriver press each hook down to release the
l
clock. Then pull out to unsnap bottom hinges.
4" x 4 and 4" x 6: From the top of the bracket, insert a thin screwdriver into each notch and gently move the
l
screwdriver sideways to unlock the clock. Then pull clock forward and up to unsnap. Lift out.

Flush-mount Installation

Follow the instructions below to install a flush-mount digital clock/timer.
Required Materials AC-Powered Models (Not Supplied)
One standard 2x4 cut to 14.5" (36.83 cm)
l
Digital Clock Model: one square shallow 4x (10.16 cm x 10.16 cm) junction box
l
Digital Timer Model: two square shallow 4x4 (10.16 cm x 10.16 cm) junction boxes
l
Four drywall anchors
l
Install a Flush-mount Digital Clock/Timer
Complete the steps below to flush-mount a digital clock/timer.
1. Cut a hole in the wall surface that is 5.4" (13.71 cm) x 14.4" (36.57 cm) between two studs.
For Power over Ethernet (PoE) models only, proceed to step 16 (steps 2 through 15 are not required for PoE models).
Figure 22: Flush-mount Wall Opening Dimensions
Primex Wireless
XR Classic Series Digital Clock/Timers Installation Guide
26