Dual-Sided Metal Series Analog Clock Installation - Primex XR Series Install Manual

Dual-Sided Metal Series Analog Clock Installation

Dual Clock Kit contents
(1) Mounting plate
(4) Long screws
(4) Wall anchors
How to mount dual-sided metal series clock
1. Secure the mounting plate to the wall or ceiling with the four long screws, paying attention to the "up" arrow, at the location
you will be hanging the clock.
2. Remove one clock from the bracket by removing two of the four factory installed screws. With the dual clock flat on a soft
surface to protect the lens and bezel, remove the two top screws and lift the top clock off of the dual mounting bracket.
NOTE
It may require some force to remove the top clock because, in addition to the screws, the clocks are also held in place by
magnets.
36
XR Analog Clock Install Guide