Primary Authentication (Radius Scheme View) - HP A5500 EI Command Reference Manual

device will look for a server in active state from scratch: the new primary server is evaluated at first and
then the secondary servers according to the order in which they are configured.
If you remove an accounting server being used by online users, the device cannot send real-time
accounting requests and stop-accounting requests anymore for the users, and does not buffer the stop-
accounting requests.
NOTE:
The shared key configured with this command takes precedence over that configured with the key
string
accounting
Related commands: key, radius scheme, state, and vpn-instance (RADIUS scheme view).
Examples
# Specify the IP address of the primary accounting server for RADIUS scheme radius1 as 10.1 10.1.2 and
the UDP port of the server as 1813.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] primary accounting 10.110.1.2 1813

primary authentication (RADIUS scheme view)

Syntax
primary authentication { ip-address [ port-number | key string | vpn-instance vpn-instance-name ] * |
ipv6 ipv6-address [ port-number | key string ] * }
undo primary authentication
View
RADIUS scheme view
Default level
2: System level
Parameters
ip-address: IPv4 address of the primary authentication/authorization server.
ipv6 ipv6-address: IPv6 address of the primary authentication/authorization server.
port-number: UDP port number of the primary authentication/authorization server, which ranges from 1 to
65535 and defaults to 1812.
key string: Specifies the shared key for exchanging authentication and authorization packets with the
primary RADIUS authentication/authorization server. A shared key is a case-sensitive string of 1 to 64
characters.
vpn-instance
authentication/authorization server belongs to, where vpn-instance-name is a case-sensitive string of 1 to
31 characters. If the server is on the public network, do not specify this keyword and argument
combination.
Description
Use the primary authentication command to specify the primary RADIUS authentication/authorization
server.
Use the undo primary authentication command to remove the configuration.
command.
vpn-instance-name: Specifies the MPLS L3VPN
51
that the primary RADIUS